Frame Tent Instructions
1)
Pre-site inspection
Call you local utility companies prior to installation for any underground obstructions.
2)
Installing the Frame Work
Layout the frame pipe & fittings according to the diagram.
( See attached sheet(s) )
Attach the perimeter pipe to the corner fittings & the "T's" with carriage bolts
Put the pipes that go from the crown to the corners together. Then the pipes from the crown to
the Regular ( or side ) "T's".
3)
Lacing the Tent
( omit if it is a 1 piece top)
Lay the tent sections over the framework, overlap the canvas with the grommet side on top of the laces.
Starting at the grommet closest to the Top, push the lace up through the grommet hole.
Next push up the next lace through the second grommet. Take the second lace & go through the first lace
loop and pull down to the third lace, take the third lace & put through the second lace loop and so on.
On the last lace, tie off.
4)
5)
Lay out the ropes perpendicular to the tent. Drive the stakes into the ground to about 8" from the top &
3' from the tent leg and tie off the tent.
6)
Raising the Tent
Raise the tent into the wind. Insert the legs for that side. Raise the opposite side & insert the legs.
Tie off the ropes to the stakes. Tighten the tent top to the frame.
8)
Take down
Loosen the ropes and disassemble in reverse order